Coatings

Low cost

Reflectance performance is flat, broad and highly

Has less sensitivity to wavelength and incident angle.

Part number : TFA, TFAN, TCA

Mechanical hardness of each coating surface is not large. Though Al+MgF2 coating can be cleaned with an organic solvent, bare Al coating can only be cleaned with a gentle stream of air due to its softness. (Al+SiO coating can be cleaned lightly.)

Improves reflectance by about 5% by replacing the normal aluminum protective coating with a multilayer coating.

Dielectric multilayers for mechanically stronger coating.

Part number : TFAE

Narrower reflection zone than aluminum coatings.

Dependent on polarization and angle, similar to dielectric multilayers.

Has less sensitivity to wavelength and incident angle.

Useful as an IR mirror, which has broad high reflectance region beyond FIR.

Part number : TFG

Since gold surface is exposed without protective coating, mechanical hardness is extremely weak and therefore should only be cleaned by a gentle stream of air.

Features high reflectance; close to 100%.

Mechanically stronger coating.

Suitable for powerful lasers.

Part number : TFM/TFM2

Narrower reflection zone and greater dependency on incident angle of light (the reflection zone varies with changes in incident angle). The reflection wavelength or reflection zone and incident angle must be specified before mirrors with dielectric-multilayer coatings are produced.

The wavelength region and reflectance of reflected light vary according to incident light polarization, except normal incidence (0° incidence).

Higher laser damage threshold than conventional dielectric-multilayer coatings.

Part number : TFMHP

Same as for dielectric-multilayer coating.

Suitable for a wider range of wavelengths.

Higher laser damage threshold than metallic films.

Constant characteristics over time; permits cleaning.

Part number : TFMS

Lower laser damage threshold and weather resistance than conventional dielectric-multilayer coatings due to multiple coating layers.